SCIMX6QP4AVT2AB datasheet(102/166 Pages) NXP

102 / 166 page

i.MX 6DualPlus/6QuadPlus Automotive Applications Processors, Rev. 3, 11/2018

102

NXP Semiconductors

Electrical Characteristics

4.12.10.6.2 LCD Interface Functional Description

Figure 62 depicts the LCD interface timing for a generic active matrix color TFT panel. In this figure,

signals are shown with negative polarity. The sequence of events for active matrix interface timing is:

•

DI_CLK internal DI clock is used for calculation of other controls.

•

IPP_DISP_CLK latches data into the panel on its negative edge (when positive polarity is selected).

In active mode, IPP_DISP_CLK runs continuously.

•

HSYNC causes the panel to start a new line. (Usually IPUx_DIx_PIN02 is used as HSYNC.)

•

VSYNC causes the panel to start a new frame. It always encompasses at least one HSYNC pulse.

(Usually IPUx_DIx_PIN03 is used as VSYNC.)

•

DRDY acts like an output enable signal to the CRT display. This output enables the data to be

shifted onto the display. When disabled, the data is invalid and the trace is off.

(DRDY can be used either synchronous or asynchronous generic purpose pin as well.)

Figure 62. Interface Timing Diagram for TFT (Active Matrix) Panels

4.12.10.6.3 TFT Panel Sync Pulse Timing Diagrams

Figure 63 depicts the horizontal timing (timing of one line), including both the horizontal sync pulse and

the data. All the parameters shown in the figure are programmable. All controls are started by

corresponding internal events—local start points. The timing diagrams correspond to inverse polarity of

the IPP_DISP_CLK signal and active-low polarity of the HSYNC, VSYNC, and DRDY signals.

m–1

HSYNC

VSYNC

HSYNC

LINE 1

LINE 2

LINE 3

LINE 4

LINE n-1

LINE n

DRDY

IPP_DISP_CLK

IPP_DATA

SCIMX6QP4AVT2AB Datenblatt(PDF) 102 Page - NXP Semiconductors