Double-click button 2 to pause or resume the auto display loop. Use button 1 to advance through the items in that menu. (Enter

“auto scrolled” menus by double clicking button 2. Enter the other menus by single clicking button 2.)

RUN Menu

The RUN menu displays the network ID, parent address, device address, current destination address, operational mode (master,

repeater, slave), and the number of received and sent data packets.

PADR. Parent’s device address, a unique number based on the parent device’s serial number and assigned by the factory. The

PADR is the 6-digit serial number minus 65535.

DADR. Device address, a unique number based on the serial number and assigned by the factory. The DADR is the 6-digit serial

number minus 65535.

DEST. The current destination address to route messages. When this displays BRDCST, the device is either in transparent mode

and is broadcasting the messages to all devices, or the device is in the early stages of Modbus mode and is broadcasting messages

to determine the paths to specific device addresses.

DEV. Reports the device type: master, repeater, or slave.

RCVD. The number of serial messages received.

SENT. The number of serial messages sent.

DINFO (Device Info) Menu

The DINFO menu displays the device information.

DEV. Reports the device type: master, repeater, or slave.

NAME. The IP Address of the Ethernet Data Radio is displayed in the following format: 192168 017017. This represents an IP

address of: 192.168.17.17

NETA. Network Address (display only).

BICD. Binding Code (display only).

FCTRY (Factory) Menu

The FCTRY menu displays the factory information about the device, including the model, dates of manufacture, and the part

numbers and version numbers of the radio, and LCD.

S/N. The device’s serial number.

Model #. The DX80ER*M family model number.

PDate. Production date.

FMP/N. Firmware part number.

FMVER. Firmware version number.

EEP/N. EE part number

EEVER. EE version number.

SITE (Site Survey) Menu

Single-click button 2 to pause/resume the auto display loop. While paused, use button 1 to advance through the GRN, YEL, RED,

and MIS displays.

DVCFG (Device Configuration) Menu

Single-click button 2 to enter this menu. Use button 1 to move through the options in this menu.

-BIND. Binding Code. Single click button 2 to manually set the binding code. Once in the binding code command, use button 2 to

select the digits; use button 1 to increment the selected digit. Press and hold button 2 to save the new binding code. The device asks

if you want to save the new setting (button 2) or discard the new setting and reselect (button 1).

-DEST. Destination Address. To force message routing when operating in transparent mode, set a specific destination address.

-FMPCT. Formation percentage, default value of 50%. This device will not form a parent/child relationship with a parent radio that

misses more than 50% of the timing beacons (approximately a 25% site survey link value). If the only option for a child is a parent

with a less than a 25% site survey link value, change this value.

Conduct a Site Survey

A site survey analyzes the radio signal between a MultiHop child radio and its parent and reports the number of data packets missed

or received at relative signal strengths.

Sure Cross® MultiHop Ethernet Data Radio

8

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 157535 Rev. H