ST10F276 datasheet(112/229 Pages) STMICROELECTRONICS

Teilenummer	ST10F276

Bauteilbeschribung	16-bit MCU with MAC unit, 832 Kbyte Flash memory and 68 Kbyte RAM

PDF	229 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

112 / 229 page

System reset

ST10F276

112/229

Synchronous reset and RPD pin

Whenever the RSTIN pin is pulled low (by external hardware or as a consequence of a

Bidirectional reset), the RPD internal weak pull-down is activated. The external capacitance

(if any) on RPD pin is slowly discharged through the internal weak pull-down. If the voltage

level on RPD pin reaches the input low threshold (around 2.5V), the reset event becomes

immediately asynchronous. In case of hardware reset (short or long) the situation goes

immediately to the one illustrated in Figure 26. There is no effect if RPD comes again above

the input threshold: the asynchronous reset is completed coherently. To grant the normal

completion of a synchronous reset, the value of the capacitance shall be big enough to

maintain the voltage on RPD pin sufficient high along the duration of the internal reset

sequence.

For a Software or Watchdog reset events, an active synchronous reset is completed

regardless of the RPD status.

It is important to highlight that the signal that makes RPD status transparent under reset is

the internal RSTF (after the noise filter).

ST10F276 Datenblatt(PDF) 112 Page - STMicroelectronics