HD6417618A datasheet(254/646 Pages) RENESAS

254 / 646 page

Section 10 Power-Down Modes

Rev. 6.00 Jun. 12, 2007 Page 222 of 610

REJ09B0131-0600

10.4

Sleep Mode

10.4.1

Transition to Sleep Mode

Executing the SLEEP instruction when the STBY bit in STBCR is 0 causes a transition from the

program execution state to sleep mode. Although the CPU halts immediately after executing the

SLEEP instruction, the contents of its internal registers remain unchanged. The on-chip peripheral

modules continue to operate in sleep mode and the clock continues to be output to the CKIO pin.

10.4.2

Canceling Sleep Mode

Sleep mode is canceled by an interrupt other than a user break (NMI, H-UDI, IRQ, and on-chip

peripheral module) or a reset.

Canceling with Interrupt: When a user-break, NMI, H-UDI, IRQ, or on-chip peripheral module

interrupt occurs, sleep mode is canceled and interrupt exception handling is executed. When the

priority level of an IRQ or on-chip peripheral module interrupt is lower than the interrupt mask

level set in the status register (SR) of the CPU, an interrupt request is not accepted preventing

sleep mode from being canceled.

Canceling with Reset: Sleep mode is canceled by a power-on reset or an H-UDI reset.

HD6417618A Datenblatt(PDF) 254 Page - Renesas Technology Corp