| Datenblatt-Suchmaschine für elektronische Bauteile |
|
H8SX/1663R Datenblatt(PDF) 606 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8SX/1663R Datenblatt(HTML) 606 Page - Renesas Technology Corp |
|
606 / 1504 page ![]() Section 12 Data Transfer Controller (DTC) Rev. 2.00 Sep. 24, 2008 Page 574 of 1468 REJ09B0412-0200 12.5 Operation The DTC stores transfer information in the data area. When activated, the DTC reads transfer information that is stored in the data area and transfers data on the basis of that transfer information. After the data transfer, it writes updated transfer information back to the data area. Since transfer information is in the data area, it is possible to transfer data over any required number of channels. There are three transfer modes: normal, repeat, and block. The DTC specifies the source address and destination address in SAR and DAR, respectively. After a transfer, SAR and DAR are incremented, decremented, or fixed independently. Table 12.2 shows the DTC transfer modes. Table 12.2 DTC Transfer Modes Transfer Mode Size of Data Transferred at One Transfer Request Memory Address Increment or Decrement Transfer Count Normal 1 byte/word/longword Incremented/decremented by 1, 2, or 4, or fixed 1 to 65536 Repeat* 1 1 byte/word/longword Incremented/decremented by 1, 2, or 4, or fixed 1 to 256* 3 Block* 2 Block size specified by CRAH (1 to 256 bytes/words/longwords) Incremented/decremented by 1, 2, or 4, or fixed 1 to 65536 Notes: 1. Either source or destination is specified to repeat area. 2. Either source or destination is specified to block area. 3. After transfer of the specified transfer count, initial state is recovered to continue the operation. Setting the CHNE bit in MRB to 1 makes it possible to perform a number of transfers with a single activation (chain transfer). Setting the CHNS bit in MRB to 1 can also be made to have chain transfer performed only when the transfer counter value is 0. Figure 12.4 shows a flowchart of DTC operation, and table 12.3 summarizes the chain transfer conditions (combinations for performing the second and third transfers are omitted). |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |