`

Copyright © 2010 Future Technology Devices International Limited

1

Document Reference No.: FT_000254

VNC2 Debug Module Datasheet Version 1.1

Clearance No.: FTDI# 149

1 Introduction

The following data sheet details the features and specifications of the VNC2 debug module. The VNC2

debug module is designed to provide connectivity between the Vinculum-II IDE development software

and the debug interface pin on the FTDI Vinculum-II (VNC2) USB host controller device.

The VNC2 debug module consists of a miniature board with a USB miniB connector, which provides USB

connectivity to Vinculum-II IDE development tools running on a PC. The VNC2 debug module can be

used to program and debug firmware running on the VNC2 device.

The module connects to the VNC2 device via a 6-way, 2mm pitch, keyed, female connector. The V2DIPx-

x, VNC2 based development modules are equipped with a compatible male connector to host the VNC2

debug module. Designers intending to use the module with their own VNC2 based hardware are required

to have a similar compatible male connector on their hardware. Details on the debug interface and

connectors are outlined in subsequent sections of this document.