114- 1056

Rev D

4

of 7

Figure 3

Pad Diameter

(As Required)

Copper Thickness (As Required)

Maximum Hardness of Copper 150 Knoop

Tin/Lead Thickness

(As Required)

Drilled Hole Diameter

(As Required)

0.89+0.13 [.035+.005] Dia

Finished Hole After Plating

3. Gripping ends of switch push switch into socket until it is bottomed.

4. Determine which of the circuits are to be closed, then depress the applicable rockers to the ON

position.

5. If installing a protective dust cover, check to be sure there are no obstructions on the switch rockers

or in the protective cover, then slide the cover over the top of the housing.

B. PC Board

1. Make a layout on pc board according to dimensions shown in Figure 2.

2. Hold switch at a slight angle and start one row of contact leads into pc board holes. Do NOT

over--insert. Switch should be rotated until second row of contact leads are aligned with opposite row of

contact holes.

3. Make certain all contact leads have started entry into holes. Grip sides of switch and push switch into

pc board until it is bottomed.

4. To hold switch in place during wave soldering, the four outside leads may be clinched inward at 45_.

SeeFigure4.

Figure 4

Clinched Solder Tail

(Inward Only)

0.76 [.030] Max