Application Specification

Dual In- Line Package (DIP)

Programming Switches

114--1056

1

of 7

LOC B

E

2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company

All Rights Reserved

*Trademark

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.

TOOLING ASSISTANCE CENTER 1--800--722--1111

PRODUCT INFORMATION 1--800--522--6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com

(7000 and 7100 Series)

03 MAY 11 Rev D

All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and

inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2_.

Figures and illustrations are for identification only and are not drawn to scale.

1. INTRODUCTION

This specification covers the requirements for application of DIP programming switches (7000 and 7100

Series) for printed circuit (pc) board applications. 7000 Series switches are designed for a life of 7,000 cycles

per pole. 7100 Series switches are recommended for programming applications where the number of cycles is

limited to 2,000 per pole.

Switches are manually rocker actuated and are designed for wave soldering on printed circuit (pc) boards or

insertion into DIP Sockets with in--row centerline spacing of 7.62 [.300]. 7000 series switches are black, and

are available in 2 through 12 positions, while 7100 series switches are blue and available in 2 through 12

positions. Both series are available with a premium seal, an economy seal, or unsealed in the raised rocker

(standard profile) or flush rocker profile (low profile). In addition, 7000 series switches are available with a side

rocker profile (side actuated). Both series are individual single--pole, single--throw (SPST). 7000 series raised

rocker profile switches may have ganged rockers for single--pole, double--throw (SPDT) and double--pole,

double--throw (DPDT) make--before--break circuits.

The unsealed switches are designed for socket applications and the sealed switches are designed for soldering

directly to the pc board. The sealants prevent flux and other contaminants from entering the switch during

soldering and cleaning. The raised rocker and side rocker profiles come unsealed or with an optional economy

or premium masking top seal. The flush rocker profile comes unsealed or with an optional economy tape top

seal or premium masking top seal. The multi--pole switches come unsealed only. All switches come standard

with a bottom seal. Switches are designed for use in logic level switching applications.

When corresponding with personnel, use the terminology provided in this specification to facilitate your

inquiries for information. Basic terms and features of this product are provided in Figure 1.

Figure 1

Raised Rocker

White Dot Identifies Pin 1

Solder Tail

Housing

Position

Number

Flush Rocker

White Dot Identifies Pin 1

Standard Profile Switch

Side Rocker Switch

Low-Profile Switch

NOTE

i