1--21000--7 datasheet(2/6 Pages) TEC

Teilenummer	1--21000--7

Bauteilbeschribung	2 mm Common Termination Head Assembly

Download	6 Pages

Scroll/Zoom	100%

Hersteller	TEC [TE Connectivity Ltd]

Direct Link	http://www.te.com/usa-en/home.html

Logo

2 / 6 page

408- 9426

Rev E

2

of 6

Adjustable Stop—controls the size of the connector

slot, permitting different size connectors to be

secured in head assembly.

Wire Guide—open channel into which unstripped

wire is inserted and bottomed for terminating.

Feed Pawl—when pushed forward, allows carriage

to be moved either right or left, depending on

where connector is to be located in head assembly.

The wire is terminated in the connector contact using

the insulation displacement technique (a terminating

technique which inserts unstripped wire into a slotted

contact beam to form a reliable electrical connection

between the wire and the contact). Contact

termination is complete when the tool is actuated.

3. SETUP

The setup procedure consists of determining the size

of the connector slot, securing the connector in that

slot, and positioning the connector for termination.

Proceed as follows:

1. To determine the size of slot required for the

connector to be terminated, push the feed pawl

forward and slide the carriage to the left as far as it

will go. Then loosen the socket head cap screw

located at bottom side of the adjustable stop

(shown in Figure 2), allowing the stop to be moved

right or left.

Figure 2

Push Feed

Pawl Forward

Socket Head

Cap Screw

Connector

Slot

Adjustable

Stop

2. Orient the connector with the head assembly as

shown in Figure 3 — the open part of the insulation

displacement slot is up and facing the back of the

tool. Making sure that the connector slot is large

enough to accept the connector, fit the connector

in slot. Then move the adjustable stop flush

against the connector, and tighten the socket head

cap screw securing the connector to the head

assembly.

3. Push the feed pawl forward and slide the

carriage (with connector) to the right as far as it will

go. Then release the feed pawl. The connector is

now in position to begin termination.

4. TEST TERMINATION AND INSPECTION

At least one termination should be performed and

inspected before starting production terminating. The

steps which follow are recommended to perform the

test termination and inspection.

Figure 3

Open Part of Contact

Insulation Displacement Slot

Up and Facing Back

of Tool

Adjustable Stop Moved

to Allow Connector to

Fit into Connector Slot

Connector

Slot

Back of

Tool (Ref)

Horizontal Mount

Header

Vertical Mount

Header

Receptacle

Assembly

1. Perform the setup procedure as described in

Section 3. Note that at the end of this procedure

the connector is in position to begin the termination

process.

2. Without inserting the wire into the wire guide,

perform one cycle. The connector will be indexed

in position for the first termination.

3. Insert an unstripped wire into the wire guide until

the wire bottoms, making sure wire is centered in

theslot. SeeFigure4.

4. Perform one termination cycle: the inserter will

bottom, forcing the wire between the contact slots,

and will then retract. The connector will advance to

the next contact position.

1--21000--7 Datenblatt(PDF) 2 Page - TE Connectivity Ltd

1--21000--7 Datenblatt(HTML) 2 Page - TE Connectivity Ltd

Ähnliche Teilenummer - 1--21000--7

Ähnliche Beschreibung - 1--21000--7

Html Pages

1 2 3 4 5 6

Datenblatt Download

Link URL