1 Introduction
The 2ED250E12-F evaluation driver board shown in Fig. 1 was developed to support customers during their
first design steps with the 1200V PrimePACK™ IGBT module. The evaluation driver board is a fully
functional IGBT module driver where two 1ED020I12-F driver IC process control and feedback signals and
provide galvanic insulation. An embedded isolated DC/DC converter supplies gate drive power to both IGBTs
of a halbridge configuration.
The 2ED250E12-F Evaluation driver boards are available from Infineon in small quantities. Functions and
properties of these parts are described in the datasheet chapter of this document whereas the remaining
paragraphs provide information intended to enable the customer to copy, modify and qualify the design for
production according to his specific requirements.
The design of the 2ED250E12-F was performed with respect to the environmental conditions described as
design target in this document. The requirements for leadfree reflow soldering have been considered when
components were selected. The design was tested as described in this documentation but not qualified
regarding manufacturing and operation in the whole operating ambient temperature range or lifetime.
The boards provided by Infineon are subjected to functional testing only.
Due to their purpose evaluation boards are not subjected to the same procedures regarding Returned
Material Analysis (RMA), Process Change Notification (PCN) and Product Discontinuation (PD) as regular products.
See Legal Disclaimer and Warnings for further restrictions on Infineon warranty and liability.

2 Design features
Electric features of the evaluation board and mechanical dimensions including interface connections are presented in following sections.

2.1 Main features
The 2ED250E12-F Evaluation Driver Board offers the following features:
• Dual channel IGBT driver utilising the 1ED020I12-F1 driver IC
• Electrically and mechanically suitable for PrimePACK™ modules 1200V family
• Integrated isolated DC/DC power supply
• Integrated protection against DC/DC power supply short circuit
• Under Voltage Lockout
• Positive logic with CMOS logic level (5V) for PWM and Fault signals. Can be converted to negative logic
• Separated fault output and ready signal for Top and Bottom IGBT
• Separated ground potential for DC/DC power supply and input logic
• Different gate resistor values for turning-on and -off are possible
• IGBTs are protected against temporary VCE overvoltages during turn-off (Active Clamping)
• Diodes for IGBT desaturation monitoring implemented (short circuit protection)
• All components, except DC/DC transformer, are surface mount devices (SMD) with lead free 260°C
soldering profile
• PCB is designed to fulfil the requirements of IEC61800-5-1, pollution degree 2, overvoltage category III