General Description
The ICS810252DI-02 is a PLL based synchronous multiplier that is
optimized for PDH or SONET to Ethernet clock jitter attenuation and
frequency translation. The device contains two internal frequency
multiplication stages that are cascaded in series. The first stage is a
VCXO PLL that is optimized to provide reference clock jitter
attenuation. The second stage is a FemtoClock® frequency multiplier
that provides the low jitter, high frequency Ethernet output clock that
easily meets Gigabit and 10 Gigabit Ethernet jitter requirements.
Pre-divider and output divider multiplication ratios are selected using
device selection control pins. The multiplication ratios are optimized
to support most common clock rates used in PDH, SONET and
Ethernet applications. The VCXO requires the use of an external,
inexpensive pullable crystal. The VCXO uses external passive loop
filter components which allows configuration of the PLL loop
bandwidth and damping characteristics. The device is packaged in a
space-saving 32-VFQFN package and supports industrial
temperature range.

Features
• Two LVCMOS/LVTTL outputs, 14 output impedance
Each output supports independent frequency selection at 25MHz,
125MHz, 156.25MHz and 312.5MHz
• Two differential input pairs support the following input types:
LVPECL, LVDS, LVHSTL, SSTL, HCSL
• Accepts input frequencies from: 8kHz to 155.52MHz including
8kHz, 1.544MHz, 2.048MHz, 19.44MHz, 25MHz, 77.76MHz,
125MHz and 155.52MHz
• Attenuates the phase jitter of the input clock by using a low-cost
pullable fundamental mode VCXO crystal
• VCXO PLL bandwidth can be optimized for jitter attenuation and
reference tracking using external loop filter connection
• FemtoClock frequency multiplier provides low jitter, high
frequency output
• Absolute pull range: ±50ppm
• FemtoClock VCO frequency: 625MHz
• RMS phase jitter @ 125MHz, using a 25MHz crystal
(10kHz – 20MHz): 1.3ps (maximum)
• 3.3V supply voltage
• -40°C to 85°C ambient operating temperature
• Lead-free (RoHS 6) packaging
• Not Recommended for New Designs. For new designs use
810N252I-02