Features
• 1‑Quadrant source measurement unit with high resolution, and measurement
flexibility:
– Programmable voltage source from 1.6 to 3.6 V
– Output current rating 500 mA with over-current protection (OCP) at
550 mA
– Programmable sampling rate from 1 SPS to 100 kSPS
– Dynamic measurement:
◦ 100 nA to 550 mA current / 160 nW to 1.65 W power
measurements
◦ 50 kHz bandwidth / 1.6 MHz acquisition / 2% accuracy
◦ Compatible with EEMBC® ULPMark™ tests
• Auxiliary output voltage source from 1.6 to 3.6 V under up to 2 A (no current
measurement, OCP at 2.5 A)
• Debugging of embedded applications:
– JTAG / Serial Wire Debug (SWD):
◦ SWD (Serial Wire Debug) and SWV (Serial Wire Viewer)
communication support up to 10 MHz
◦ JTAG communication support up to 20 MHz
– UART interface on Virtual COM port (VCP) with frequency up to 12 MHz
– Multi-path bridge USB to SPI/I2C/CAN/GPIOs
– Integrated level shifter I/O voltage 1.6 to 3.6V adaptable
• Four bi-color LEDs providing probe state
• Three STDC14 to MIPI10 / STDC14 / MIPI20 flat cables with 1.27 mm pitch
connectors
• Four cables (two male/male and two male/female)
• USB Type-C® connector:
– Powered through USB Type-C® (5 V/3 A maximum)
– USB 2.0 high‑speed interface
– Probe firmware update through USB
• Direct support from STM32CubeMonitor-Power software tool