Microcontroller Features
•Low Pin Count Packages, Ranging from 20 to 36 Pins, including UQFN as Small as 4x4 mm
•Up to 64K Flash Memory:
-20,000 erase/write cycle endurance
-20 years minimum data retention
-Self-programmable under software control
•Up to 8K Data Memory
•Pin-Compatible with Most PIC24 MCU/dsPIC® DSC Devices
•Multiple Interrupt Vectors with Individually Programmable Priority
•Fail-Safe Clock Monitor mode
•Configurable Watchdog Timer with On-Chip, Low-Power RC Oscillator
•Programmable Code Protection
•Selectable Oscillator Options including:
-High-precision, 8 MHz internal Fast RC (FRC) oscillator
-High-speed crystal/resonator oscillator or external clock
-2x/3x/4x/6x/12x/24x PLL, which can be clocked from the FRC or primary oscillator

Peripheral Features
•Atomic Set, Clear and Invert Operation on Select Peripheral Registers
•High-Current Sink/Source 11 mA/16 mA on All Ports
•Independent, Low-Power 32 kHz Timer Oscillator
•Two 4-Wire SPI modules (up to 25 Mbps):
-16-byte FIFO
-I2S mode
•Two UARTs:
- RS-232, RS-485 and LIN/J2602 support
- IrDA® with on-chip hardware encoder and decoder
•External Edge and Level Change Interrupt on All Ports
•CRC module
•Hardware Real-Time Clock and Calendar (RTCC)
•Up to 20 Peripheral Pin Select (PPS) Remappable Pins
•Seven Total 16-Bit Timers:
-Timer1: Dedicated 16-bit timer/counter
-Two additional 16-bit timers in each MCCP and SCCP module
•Capture/Compare/PWM/Timer modules:
-Two 16-bit timers or one 32-bit timer in each module
-PWM resolution down to 21 ns
-One Multiple Output (MCCP) module:
-Flexible configuration as PWM, input capture, output compare or timers
-Six PWM outputs
-Programmable dead time
-Auto-shutdown
-Two Single Output (SCCP) modules:
-Flexible configuration as PWM, input capture, output compare or timers
-Single PWM output
•Reference Clock Output (REFO)
•Two Configurable Logic Cells (CLC) with Internal Connections to Select Peripherals and PPS

Debug Features
•Two Programming and Debugging Interfaces:
-2-wire ICSP™ interface with non-intrusive access and real-time data exchange with application
-4-wire MIPS® standard Enhanced JTAG interface
•IEEE Standard 1149.2 Compatible (JTAG) Boundary Scan

Analog Features
•Two Analog Comparators with Input
Multiplexing
•Programmable High/Low-Voltage
Detect (HLVD)
•5-Bit DAC with Output Pin
•Up to 14-Channel, Software-Selectable 10/12-Bit SAR Analog-to-Digital Converter (ADC):
-12-bit, 200K samples/second conversion rate (single Sample-and-Hold)
-10-bit, 300K samples/second conversion rate (single Sample-and-Hold)
-Sleep mode operation
-Band gap reference input feature
-Windowed threshold compare feature
-Auto-scan feature
•Brown-out Reset (BOR)