TWO-OUTPUT LNB SUPPLY AND CONTROL-VOLTAGE REGULATOR

Intended for analog and digital satellite receivers, the low noise block converter regulator (LNBR) is a monolithic linear and switching voltage regulator designed to provide power and interface signals to the LNB downconverter via the coaxial cable. Because most satellite receivers have two antenna ports, the output voltage of the regulator is available at one of two logic-selectable output terminals (LNBA, LNBB). If the device is in stand-by mode (EN terminal LOW), both regulator outputs are disabled, allowing the antenna downconverters to be supplied and controlled by other satellite receivers sharing the same coaxial cable. Similar single-output devices, with a bypass function for slave operation in single-dish dual-receiver systems, are the A8283SB/SLB.

FEATURES
■ Complete Interface for Two LNBs Remote Supply and Control
■ LNB Selection and Stand-By Function
■ Built-In Tone Oscillator Factory Trimmed to 22 kHz, Facilitates
   DiSEqC™ (a trademark of EUTELSAT) Encoding
■ Full Modulation With No Load
■ Tracking Switch-Mode Power Converter for Lowest Dissipation
■ Externally Adjustable Short-Circuit Protection
■ LNB Short-Circuit Protection and Diagnostics
■ Auxiliary Modulation Input
■ Cable Length Compensation
■ Internal Over-Temperature Protection