LifecyclePhase:

Revision

: 1

Expired Period: Forever

Release Date:2016-05-13 17:09:27.0

DATASHEET

Display

 Through-hole

EADCF056RA3

6

Copyright © 2010, Everlight Americas Inc. All Rights Reserved. Release Date : May 12, 2016

Issue No : DDF-0002367. Rev.1

www.everlightamericas.com

Application Restrictions

1. Specification described in this document. Above specification may be changed without notice. Everlight

Americas

will reserve authority on material change for above specification.

2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in

these specification sheets. Everlight

product which does not comply with the absolute maximum ratings and the instructions included in these

specification sheets.

3. These specification sheets include materials protected under copyright of Everlight

don’t reproduce or cause anyone to reproduce them without Everlight

4. ESD (Electrostatic Discharge)



The products are sensitive to static electricity or surge voltage. ESD can damage a die and its reliability.

When handling the products, the following measures against electrostatic discharge are strongly

recommended:

Eliminating the charge

Grounded wrist strap, ESD footwear, clothes, and floors

Grounded workstation equipment and tools

ESD table/shelf mat made of conductive materials



Proper grounding is required for all devices, equipment, and machinery used in product assembly.

Surge protection should be considered when designing of commercial products.



If tools or equipment contain insulating materials such as glass or plastic,

the following measures against electrostatic discharge are strongly recommended:

Dissipating static charge with conductive materials

Preventing charge generation with moisture

Neutralizing the charge with ionizers

5. The LEDs should be operated with forward bias. The driving circuit must be designed so that the LEDs are not

subjected to forward or reverse voltage while it is off. If reverse voltage is continuously applied to the LEDs, it may

cause migration resulting in LED damage.