DS3102 datasheet(3/4 Pages) TTELEC

3 / 4 page

Loop Powered Indicator

DS3102

General Note

TT Electronics reserves the right to make changes in product specification without

notice or liability. All information is subject to TT Electronics’ own data and is

considered accurate at time of going to print.

Issue A

07/2018 Page 3

TT Electronics | Roxspur Measurement & Control

2 Downgate Drive, Sheffield, South Yorkshire, S4 8BT, UK |Ph: +44 (0) 114-244-2521

www.ttelectronics.com | RoxspurSales@ttelectronics.com

Example Range 50/150oC, Span 100oC

a) Check ‘Decimal Point’ link set to 100oC.

b) Remove 'Range' link and set to normal position.

c) Turn coarse offset potentiometer fully clockwise.

d) Set current to 16mA and adjust coarse and then fine span potentiometers until display reads 100oC.

e) Set current to 4mA and adjust coarse and the fine offset potentiometers until display reads 50oC.

f ) Set current to 20mA and check display reads 150oC.

g) Set current to 12mA and check display reads 100oC, ±1 count.

h) Switch off supply and remove test equipment.

DS3102 Datenblatt(PDF) 3 Page - TT Electronics.