GD25VQ127CSFS datasheet(33/62 Pages) GIGADEVICE

33 / 62 page

Uniform Sector

Dual and Quad Serial Flash

GD25VQ127C

Figure27. Read Manufacture ID/ Device ID Quad I/O Sequence Diagram

7.25.

Read Identification (RDID) (9FH)

The Read Identification (RDID) command allows the 8-bit manufacturer identification to be read, followed by two bytes

of device identification. The device identification indicates the memory type in the first byte, and the memory capacity of the

device in the second byte. The Read Identification (RDID) command while an Erase or Program cycle is in progress is not

decoded, and has no effect on the cycle that is in progress. The Read Identification (RDID) command should not be issued

while the device is in Deep Power-Down Mode.

The device is first selected by driving CS# low. Then, the 8-bit command code for the command is shifted in. This is

followed by the 24-bit device identification, stored in the memory. Each bit is shifted out on the falling edge of Serial Clock.

The command sequence is shown in Figure28. The Read Identification (RDID) command is terminated by driving CS#

high at any time during data output. When CS# is driven high, the device is in the Standby Mode. Once in the Standby

Mode, the device waits to be selected, so that it can receive, decode and execute commands.

Command

94H

CS#

SCLK

SI(IO0)

SO(IO1)

9 10 11 12 13 14 15

16 17 18 19 20 21 22 23

A23-16 A15-8 A7-0

M7-0

WP#(IO2)

HOLD#(IO3)

Dummy

MFR ID

DID

CS#

SCLK

SI(IO0)

SO(IO1)

WP#(IO2)

HOLD#(IO3)

24 25 26 27 28 29 30 31

MFR ID

(Repeat)

DID

(Repeat)

MFR ID

(Repeat)

DID

(Repeat)

GD25VQ127CSFS Datenblatt(PDF) 33 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25VQ127CSFS Datenblatt(HTML) 33 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datenblatt Download

Link URL