Push Button Lockout

•

Prevents unwanted adjustments or tampering of the push buttons.

•

Push buttons can be enabled or disabled only from the remote line and only during normal RUN mode.

Remote input pulse: 0.04 s ≤ T ≤ 0.8 s

Method

Action

Result

Push Button

Not available with push-button

programming

Push Buttons Disabled

•

Display flashes “loc”

•

Padlock icon appears

•

Sensor remains in RUN mode

Push Buttons Enabled

•

Display flashes “uloc”

•

Padlock icon disappears

•

Sensor remains in RUN mode

Remote Input

From RUN mode, quad-pulse the remote

line to toggle between selections

Gate Input

The pink wire is configured as a gate input. When this wire is pulled low (e.g., to the sensor ground), it inhibits the outputs

from switching while all other sensor functions continue to be enabled. This feature is useful for controlling when the

outputs are allowed to change states. Gate input function response time is 1 millisecond.

Single-Point Window SET

A Window SET sets a single output condition that extends above

and below the taught condition by a selectable offset percentage (2,

3, 4, 5, or 10%).

In Dark Operate, a Window SET sets a single OFF condition that

extends above and below the taught condition. All other conditions

(lighter or darker) result in ON output.

In Light Operate, a Window SET sets a single ON condition that

extends above and below the taught condition. All other conditions

(lighter or darker) result in OFF output.

Output ON and OFF conditions can be reversed by changing Light/

Dark Operate status in SETUP mode.

Remote input pulse: 0.04 s ≤ T ≤ 0.8 s

Sensor positions

window thresholds

from the taught

condition

Darkest

(no signal)

Most Light

(saturated

signal)

Taught

Condition

Offset %

Offset %

Output ON

Output ON

Output OFF

Figure 2. Single-point Window Set and Offset Percentage

(Dark Operate Shown)

D10 Expert Series - Small Object Counter

P/N 146132 Rev. D

www.bannerengineering.com - tel: 763-544-3164

7