• Light or Dark Operate

• 30-millisecond pulse stretcher (OFF-delay), if required

• 30-millisecond ON-delay, if required

Setup mode is also used to disable one or more sensing beam colors, to force the sensor to use a particular color. Access Setup mode

only if the settings which result from TEACH mode configuration are not the settings required for the application or if a delay is required.

The status LEDs indicate the output response configuration when the sensor is in Run mode, as shown.

LO

No delay

DO

No delay

LO

OFF-delay

DO

OFF-delay

LO

ON-delay

DO

ON-delay

LO

OFF-delay

ON-delay

DO

OFF-delay

ON-delay

Increment or decrement through the 8 possible setting combinations

Double-Pulse or

Static Push Button

Single-Pulse or

Dynamic Push Button

Figure 7. Output Response Configuration Options

All Colors

Red

Green

Blue

Red and

Green

Red and

Blue

Green and

Blue

Increment or decrement through the 7 possible setting combinations

Double-Pulse or

Static Push Button

Single-Pulse or

Dynamic Push Button

Figure 8. LED Color Configuration Options

Change the output response settings or disable sensing beam color(s) as shown in Setup Configuration on page 7.

Note: If Setup mode programming is interrupted and remains inactive for 60 seconds, the sensor returns to Run

mode with the most recent settings (that is, exits and saves the current selection).

Setup Configuration

1. Enter Setup mode.

Method

Action

Result

Push Button6

Press and hold both Static (-) and Dynamic (+) for > 2 seconds.

The 8-segment display turns off.

The sensor is in Setup mode.

Remote Input7

Double-pulse the remote input.

T

T

T

6 0.04 seconds ≤ “click” ≤ 0.8 seconds

7 0.04 seconds ≤ “T” ≤ 0.8 seconds

P/N 122928 Rev. D

www.bannerengineering.com - Tel: +1-763-544-3164

7