Specifications

Supply Voltage and Current

Operating Voltage: 12 to 30V dc

Current Draw: 400 mA max.

Pulse Width Modulation (PWM)

Frequency: Up to 40 kHz

Voltage: 5 to 30 V dc

Current: 15 mA max.

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Light Source

Three high-intensity LEDs; see models table for color temperature

Useful Life

When operating within specifications, output will decrease less than

30% after 50,000 hours.

Construction

316 stainless steel housing, polycarbonate or glass window with Viton

seal, 316 stainless steel M30 mounting nut, FDA grade silicon base

gasket

Mounting

30x1.5 mm thread base mount

Connections

Integral 5-pin M12/Euro style QD; 4-pin connecting cordset required

for QD models; only 2 wires used

Environmental Rating

IEC IP67, IP69K per DIN 40050-9

NOTE: Do not spray the cable with a

high-pressure sprayer or cable damage

will result.

Operating Conditions

-20° to +50°C (-4° to +122°F)

95% max. relative humidity (non-condensing)

Vibration and Mechanical Shock

All models meet Mil. Std. 202F requirements method 201A (vibration:

10 to 60 Hz max., double amplitude 0.06", maximum acceleration

10G). Also meets IEC 947-5-2; 30G 11 ms duration, half sine wave.

Storage Temperature

−40 °C to +70 °C (−40 °F to +158 °F)

95% maximum relative humidity (non-condensing)

Certifications

Approvals are pending

Beam Patterns

Percentage of Maximum Light Intensity

Per Lens Type at 0.5 Meter (Typical)

Percentage of Maximum Light Intensity Per Lens Type at 1 Meter

(Typical)

0%

25%

50%

75%

100%

-30

-20

-10

0

10

20

30

Light Pattern From Center (cm)

±5º ±11º ±20º

0%

25%

50%

75%

100%

-60

-50

-40

-30

-20

-10

0

10

20

30

40

50

60

Light Pattern From Center (cm)

±5º

±11º

±20º

WL50S Stainless Steel High-Intensity Spot Light - PWM Dimmable

2

www.bannerengineering.com - tel: 763-544-3164

P/N 179497 Rev. A