Datasheet

Chemically Resistant LED work lighting

•

Three lens options, depending on model, to vary spot size

•

Illuminates a large area with an even pattern of light and no shadows

•

12 to 30 V dc operation

•

56 mm (2.2 in) diameter with flat profile and 30 mm (1.2 in) mounting base

•

•

Chemically resistant 316 stainless steel housing for use in harsh environments

•

FDA grade silicone gasket

WARNING: Not To Be Used for Personnel Protection

Never use this device as a sensing device for personnel protection. Doing so could lead to

serious injury or death. This device does not include the self-checking redundant circuitry necessary

to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an

energized or de-energized sensor output condition.

Models

Model

LED Color

Window Material

Lumens

Lux

Lens Angle (see

Beam Patterns

on page 2)

Connection

0.5 m

1 m

WL50SWSSL5Q

White,

5000–8300 K

Polycarbonate

295

13780

3445

±5°

small, more

focused spot

5 pin Euro integral QD

connector (use with a 4-

wire or 5-wire mating

cordset, only 2 wires used

for connection)

WL50SWSSGL5Q

Glass

WL50SWSSL11Q

Polycarbonate

285

5460

1365

±11°

larger spot

WL50SWSSGL11Q

Glass

WL50SWSSL20Q

Polycarbonate

270

2000

500

±20°

largest spot

WL50SWSSGL20Q

Glass

Specifications

Supply Voltage and Current

Operating Voltage: 12 to 30 V dc

Current Draw: 400 mA maximum

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Light Source

Three high-intensity LEDs; see models table for color temperature

Useful Life

When operating within specifications, output will decrease less than

30% after 50,000 hours.

Construction

316 stainless steel housing, polycarbonate or glass window with Viton

seal, 316 stainless steel M30 mounting nut, FDA grade silicon base

gasket

Mounting

30 × 1.5 mm thread base mount

Connections

Integral 5-pin M12 quick disconnect fitting; 4-pin connecting cordset

required for quick disconnect fitting models; only 2 wires used

Environmental Rating

IEC IEC IP67, IEC IP69K per DIN 40050-9

NOTE: Do not spray the cable with a

high-pressure sprayer or cable damage

will result.

Operating Conditions

–20 °C to +50 °C (–4 °F to +122 °F)

95% maximum relative humidity (non-condensing)

Vibration and Mechanical Shock

All models meet Mil. Std. 202F requirements method 201A (vibration:

10 to 60 Hz max., double amplitude 0.06", maximum acceleration

10G). Also meets IEC 947-5-2; 30G 11 ms duration, half sine wave.

Storage Temperature

−40 °C to +70 °C (−40 °F to +158 °F)

95% maximum relative humidity (non-condensing)

Certifications

Approvals are pending

WL50S Stainless Steel High-Intensity Work

Spot Light

Original Document

168649 Rev. D

19 December 2016

168649