- 2 -

Epoxy Adhesives

DP110 Translucent and Gray

Typical Cured

Thermal Properties

Typical Cured

Electrical Properties

Note: The following technical information and data should be considered representative

or typical only and should not be used for specification purposes.

Product

3M™ Scotch-Weld™

Epoxy Adhesive

DP110 Translucent

3

M™ Scotch-Weld™

Epoxy Adhesive

DP110 Gray

Thermal Conductivity

.106 @ 113°F (45°C)

.104 @ 113°F (45°C)

Thermal Coefficient of Expansion

-58°F (-50°C) - 32°F (0°C)

-58°F (-50°C) - 166°F (110°C)

Glass Transition Temp.

55°F (13°C)

61°F (16°C)

Note: The following technical information and data should be considered representative

or typical only and should not be used for specification purposes.

Product

3M Scotch-Weld

Epoxy Adhesive

DP110 Translucent

3M Scotch-Weld

Epoxy Adhesive

DP110 Gray

Dielectric Strength (volts/mil)

520

470

Volume Resistivity (ohms - cm)

Typical Adhesive

Performance

Characteristics

Note: The following technical information and data should be considered representative

or typical only and should not be used for specification purposes.

The following product performance data was obtained in the 3M laboratory under

the conditions specified. The following data show typical results obtained with

Scotch-Weld epoxy adhesive DP110 Translucent and Gray when applied to

properly prepared substrates and cured for 48 hours at 73°F (23°C) under 2 psi

pressure and tested according to the specifications indicated.

Note: All data developed after a 48 hour cure @ 75°F (24°C) under 2 psi pressure

unless noted otherwise.

A. Aluminum Overlap Shear

Overlap shear strength was measured on FPL etched 1 in. wide by 1/2 in. overlap

specimens. The bonds were made from 2 panels of 4 in. x 7 in. x .063 in., 2024 T3

clad aluminum bonded together and cut into 1 in. wide specimens. The separation

rate of the testing jaws was .1 in./minute. Tests similar to ASTM D-1002.

Test Temp

3M Scotch-Weld

Epoxy Adhesive

DP110 Translucent

3M Scotch-Weld

Epoxy Adhesive

DP110 Gray

-67°F (-55°C)

2500 psi

2700 psi

75°F (24°C)

2500 psi

3500 psi

160°F (71°C)

270 psi

270 psi

180°F (82°C)

200 psi

250 psi