IS25LP064A-RBLA1 datasheet(21/99 Pages) ISSI

Teilenummer	IS25LP064A-RBLA1

Bauteilbeschribung	3V SERIAL FLASH MEMORY WITH 133MHZ MULTI I/O SPI & QUAD I/O QPI DTR INTERFACE

PDF	99 Pages

Scroll/Zoom	100%

Hersteller	ISSI [Integrated Silicon Solution, Inc]

Direct Link	http://www.issi.com

Logo

21 / 99 page

IS25LP064A/032A

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A

11/06/2015

7. PROTECTION MODE

The IS25LP064A/032A supports hardware and software write-protection mechanisms.

7.1 HARDWARE WRITE PROTECTION

The Write Protection (WP#) pin provides a hardware write protection method for BP3, BP2, BP1, BP0, SRWD,

and QE in the Status Register. Refer to the section 6.1 STATUS REGISTER.

Write inhibit voltage (VWI) is specified in the section 9.8 POWER-UP AND POWER-DOWN. All write sequence

will be ignored when Vcc drops to VWI.

Table 7.1 Hardware Write Protection on Status Register

SRWD

WP#

Status Register

Low

Writable

Low

Protected

High

Writable

High

Writable

Note: Before the execution of any program, erase or write Status/Function Register instruction, the Write Enable

Latch (WEL) bit must be enabled by executing a Write Enable (WREN) instruction. If the WEL bit is not

enabled, the program, erase or write register instruction will be ignored.

7.2 SOFTWARE WRITE PROTECTION

The IS25LP064A/032A also provides a software write protection feature. The Block Protection (TBS, BP3, BP2,

BP1, BP0) bits allow part or the whole memory area to be write-protected.

IS25LP064A-RBLA1 Datenblatt(PDF) 21 Page - Integrated Silicon Solution, Inc