Ver.1.05

ATBA-32F, ATBA-8F

2

Connect a Board/Card

Board/Card Connection

*1: To obtain an effective buffer amp connection, connectthis unit near to the analog input board. Using a 0.5 m

Shield Cable is recommended.

Correspondence Products (Optional)

Board for PCI Express : AIO-163202F-PE

Board for PCI

: ADA16-32/2(PCI)F

USB I/O Unit

: AIO-163202FX-USB

Cables (Optional)

Shielded cable with a 96-pin half-pitch connectors on 2 Ends

: PCB96PS-0.5P (0.5m), PCB96PS-1.5P (1.5m)

Flat cable with a 96-pin half-pitch connectors on 2 Ends

: PCB96P-1.5 (1.5m),

Shielded cable with a 96-pin half-pitch connector to open-ended

: PCA96PS-0.5P (0.5m), PCA96PS-1.5P (1.5m)

Flat able with a 96-pin half-pitch connector to open-ended:

PCA96P-1.5 (1.5m)

68/96-pin conversion shielded cable for analog input/output

: ADC-68M/96F (0.5m) *1

*1 ATBA-32F, ATBA-8F uses this cable when connecting the PC card.

Connecting an External Power Supply

Because the corresponding analog board/card have not voltage output,

an external power supply is required to make the terminal work.

Items

Specification

Power Voltage

5VDC

Voltage Tolerance

±5%

Current Capacity

0.85A or larger

A bundled connector plug (MC1,5/3-ST-3,5, Phoenix Contact. Suitable

wire: AWG28 - 16) can help you to connect the external power supply.

When you using this MC1,5/3-ST-3,5 plug to connect the external power

supply, please strip the end of the corresponding wire, insert it into the

connector plug, then fix the screw to secure.

There is an optional AC adapter available from CONTEC.

Accessories (Optional):

AC adapter

(Input: 90 - 264VAC, Output: 5VDC 2.0A)

: POA200-20

When using the external power supply:

The terminal can provide the maximum power supply of 5VDC, 2A.

To use the AC adapter, please connect it to the terminal first, then

plug the AC adapter into a outlet.

When the terminal is not used, please leave the AC adapter

unplugged.

Continuously using the AC adapter under high temperature

environment will affect its life.

Use the AC adapter not in a closed place but in a well-ventilated

place. The AC adapter heats up itself when loaded heavily. If the

AC adapter is exposed to high temperature or used continuously,

you should keep the load at about 80% of the maximum load.

- Please use the DC cable with a length of less than 1m to meet “CE

EMC Directive”.

ATBA-32F

or

ATBA-8F

CN2

CN1

Cable2

(Sold separately)

Remote device side

Board side

Analog input board

Cable1

(Sold separately)

Analog input

card

CAUTION

+5VDC

FG Vi- Vi+

FG

Vi-

Vi+

Frame ground

Power supply(GND)

Power supply(5V)