MAXQ1065EVKIT datasheet(3/9 Pages) MAXIM

3 / 9 page

Maxim Integrated │ 3

www.maximintegrated.com

Evaluates: MAXQ1065

MAXQ1065 Evaluation Kit

Linux is a registered trademark of Linus Torvalds.

Windows is a registered trademark of Microsoft Corporation.

Detailed Hardware Description

EV Kit Supported Platforms

The MAXQ1065 EV kit is designed to be compatible with

a variety of platforms: PC, Raspberry Pi, Arduino Uno,

and custom motherboards. All supported platforms must

provide their own 5V power supply to the MAXQ1065

socket board to ensure proper operation.

The MAXQ1065 socket board is compatible with multiple

PC platforms, such as Linux® and Windows®. It includes

an onboard USB connector and uses an FTDI bridge

chip, the FT4222H, to enable a USB-to-SPI interface

with the MAXQ1065 EV kit. A 5V power supply must

be provided from the PC through the USB connector to

ensure proper operation of the socket board. The follow-

ing steps can be used to properly set up the MAXQ1065

socket board with a PC platform:

1) Adjust the VDD SEL switch (SW1) to the 3V3 position.

2) Connect the MAXQ1065 socket board to the PC

using the USB cable.

Raspberry Pi

The MAXQ1065 socket board is also compatible with

Raspberry Pi 3 Model B/B+ and Raspberry Pi 2 Model

B through the socket board’s JH3 connector. In order

to provide clearance between the socket board and the

Raspberry Pi, the included Raspberry Pi-compatible

elevated header must be installed before attempting to

connect the two boards together. The following steps can

be used to properly set up the MAXQ1065 socket board

with a Raspberry Pi platform:

1) Ensure that the Raspberry Pi board is powered off.

2) Connect the elevated header onto the bottom side of

the JH3 connector, as shown in Figure 2.

3) Adjust the VDD SEL switch (SW1) to the 3V3 position.

4) Connect the MAXQ1065 socket board on top of the

Raspberry Pi, as shown in Figure 3.

5) Power on the Raspberry Pi board through its own

USB connector, as shown in Figure 4.

Figure 2. MAXQ1065 Socket Board with an Elevated Header

Installed

Figure 3. MAXQ1065 Socket Board Attached to a Raspberry Pi

through an Elevated Header

MAXQ1065EVKIT Datenblatt(PDF) 3 Page - Maxim Integrated Products

MAXQ1065EVKIT Datenblatt(HTML) 3 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9

Datenblatt Download

Link URL