M69KB096AB datasheet(13/73 Pages) STMICROELECTRONICS

13 / 73 page

M69KB096AB

3 Power-up

13/73

Power-up

To guarantee correct operation, a specific Power-Up sequence must be followed to initialize the

M69KB096AB. Power must be applied simultaneously to VCC and VCCQ. Once VCC and VCCQ

have reached a stable level (see Figure 35: Deep Power-Down Entry and Exit AC Waveforms

and Figure 34: Power-Up AC Waveforms), the device will require tVCHEL to complete its self-

initialization process. During the initialization period, the E signal must remain High. Once

initialization has completed, the device is ready for normal operation.

Initialization will load the Bus Configuration Register (BCR) and the Refresh Configuration

and Table 11: Refresh Configuration Register Definition).

Low-power modes

4.1

Standby

When the device is in Standby, the current consumption is reduced to the level necessary to

perform the memory array refresh operation. The device will enter Standby when a read or

write operation is completed, depending on the operating mode (Asynchronous, NOR-Flash

Synchronous or Full Synchronous).

For details on how to enter Standby, refer to Table 3: Standard Asynchronous Operating

Modes, Table 5: Asynchronous Write Operations (NOR-Flash Synchronous Mode) and Table 6:

Synchronous Read Operations (NOR-Flash Synchronous Mode).

4.2

Deep Power-Down

Deep Power-Down (DPD) is used by the system memory microcontroller to disable the PSRAM

device when its storage capabilities are not needed. All refresh operations are then disabled.

For the device to enter Deep Power-Down, bit 4 of the RCR must be set to ‘0’ and Chip Enable,

E, must go High, VIH. When the Deep Power-Down is enabled, the data stored in the device

may be corrupted and BCR, RCR and DIDR content are saved.

For the device exits Deep Power-Down by driving Chip Enable, E, Low, VIL. Bit 4 of the RCR will

be automatically set to ‘1’. Once the Deep Power-Down is exited, the device will be available for

normal operations after tVCHEL (time to perform an initialization sequence) During this delay, the

current consumption will be higher than the specified Standby levels, but considerably lower

than the active current. The content of the registers will be restored after Deep Power-Down.

For details on how to enter Deep Power-Down, refer to Table 3: Standard Asynchronous

Operating Modes, Table 5: Asynchronous Write Operations (NOR-Flash Synchronous Mode)

and Table 6: Synchronous Read Operations (NOR-Flash Synchronous Mode).

M69KB096AB Datenblatt(PDF) 13 Page - STMicroelectronics