PCIMX6DP4AVT2AB datasheet(137/166 Pages) NXP

137 / 166 page

Electrical Characteristics

i.MX 6DualPlus/6QuadPlus Automotive Applications Processors, Rev. 3, 11/2018

NXP Semiconductors

137

4.12.23 USB PHY Parameters

This section describes the USB-OTG PHY and the USB Host port PHY parameters.

The USB PHY meets the electrical compliance requirements defined in the Universal Serial Bus Revision

2.0 OTG, USB Host with the amendments below (On-The-Go and Embedded Host Supplement to the USB

Revision 2.0 Specification is not applicable to Host port).

•

USB ENGINEERING CHANGE NOTICE

— Title: 5V Short Circuit Withstand Requirement Change

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

Errata for USB Revision 2.0 April 27, 2000 as of 12/7/2000

•

USB ENGINEERING CHANGE NOTICE

— Title: Pull-up/Pull-down resistors

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

USB ENGINEERING CHANGE NOTICE

— Title: Suspend Current Limit Changes

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

USB ENGINEERING CHANGE NOTICE

— Title: USB 2.0 Phase Locked SOFs

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

On-The-Go and Embedded Host Supplement to the USB Revision 2.0 Specification

— Revision 2.0 plus errata and ecn June 4, 2010

•

Battery Charging Specification (available from USB-IF)

— Revision 1.2, December 7, 2010

— Portable device only

PCIMX6DP4AVT2AB Datenblatt(PDF) 137 Page - NXP Semiconductors