SR2 datasheet(6/22 Pages) STMICROELECTRONICS

6 / 22 page

Pin descriptions

SR2

6/22

DocID026047 Rev 2

Pin descriptions

2.1

Power supply (VCC)

This pin is used to provide power to the Smart Reset™ device. A 0.1 µF ceramic decoupling

capacitor is recommended to be connected between the VCC and VSS pins, as close to the

SR2 device as possible.

2.2

Ground (VSS)

Ground pin for the device.

2.3

Smart Reset™ input (SR0)

Push-button Smart Reset™ input is active low with optional pull-up resistor. Both SR

inputs need to be asserted simultaneously for at least tSRC to assert the reset output (RST).

By connecting a voltage higher than VCC to the SR0 the device enters a test mode (see

Section 1: Description on page 3 for more information).

2.4

Smart Reset™ input (SR1)

Push-button Smart Reset™ input is active low with optional pull-up resistor. Both SR inputs

need to be asserted simultaneously for at least tSRC to assert the reset output (RST).

2.5

Reset output (RST)

RST is active low or active high, push-pull or open drain reset output with optional internal

pull-up resistor. Output reset pulse width is optional as follows:



Neither fixed nor minimum output reset pulse duration (releasing the push-button while

reset output is active, causes the output to deassert);



Fixed, factory-programmed output reset pulse duration for tREC independent on Smart

Reset™ input state.

If VCC drops below 1.575 V, the RST output is deasserted and its state is guaranteed down

to 1 V (see Figure 8).

SR2 Datenblatt(PDF) 6 Page - STMicroelectronics