 |
Datenblatt-Suchmaschine für elektronische Bauteile |
|
|
Datenblatt-Suchmaschine für elektronische Bauteile |
|
ST25DV16K Datenblatt(PDF) 6 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST25DV16K Datenblatt(HTML) 6 Page - STMicroelectronics |
|
|
6 / 200 page  2 Signal descriptions 2.1 Serial link (SCL, SDA) 2.1.1 Serial clock (SCL) This input signal is used to strobe all data in and out of the ST25DVxxx. In applications where this signal is used by slave devices to synchronize the bus to a slower clock, the bus master must have an open drain output, and a pull-up resistor must be connected from Serial Clock (SCL) to VCC. See Section 9.2 I2C DC and AC parameters to know how to calculate the value of this pull-up resistor 2.1.2 Serial data (SDA) This bidirectional signal is used to transfer data in or out of the ST25DVxxx. It is an open drain output that may be wire-OR’ed with other open drain or open collector signals on the bus. A pull-up resistor must be connected from Serial Data (SDA) to VCC. (Figure 76. I2C Fast mode (fC = 1 MHz): maximum Rbus value versus bus parasitic capacitance (Cbus) indicates how the value of the pull-up resistor can be calculated). 2.2 Power control (VCC, LPD,VSS) 2.2.1 Supply voltage (VCC) This pin can be connected to an external DC supply voltage. Note: An internal voltage regulator allows the external voltage applied on VCC to supply the ST25DVxxx, while preventing the internal power supply (rectified RF waveforms) to output a DC voltage on the VCC pin. 2.2.2 Low Power Down (LPD) This input signal is used to control an internal 1.8 V regulator delivering ST25DVxxx internal supply. When LPD is high, this regulator is shut off and its consumption is reduced below 1µA. This regulator has a turn on time in range of 100us, to be added to the boot duration, before the device becomes fully operational. The impedance on LDP pin when set high doesn't exceed 5kΩ. This feature is only available on the 10-ball and 12-pin ST25DVxxx package. The LPD pin is internally pulled- down. 2.2.3 Ground (VSS) VSS is the reference for the VCC and VDCG supply voltages and V_EH analog output voltage. ST25DV04K ST25DV16K ST25DV64K Signal descriptions DS10925 - Rev 9 page 6/200 |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
German ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
