USB7016TSLASHKDX datasheet(13/60 Pages) MICROCHIP

13 / 60 page

 2022 Microchip Technology Inc. and its subsidiaries

DS00003740B-page 13

USB7016

USB Type-C Connector Control

Downstream

Port 1 Type-C

Voltage Monitor

DP1_VBUS_MON

AIO

Used to detect Type-C VBUS vSafe5V and

vSafe0V states on Port 1. Externally, VBUS

can be as high as 5.5 V, which can be dam-

aging to this pin. The amplitude of VBUS

must be reduced by a voltage divider. The

recommended voltage divider is shown

below. 1% tolerance resistors are recom-

mended.

Note:

For proper Type-C port opera-

tion, it is critical that this pin actu-

ally be connected to VBUS of the

port through the recommended

resistor divider. This pin should

not be tied permanently to a

fixed voltage power rail.

Note 3-3

If unused: Weak pull-down

to GND. This pin may be

left unused if Port 1 is

disabled or reconfigured to

operate in legacy Type-A

mode

t hrough

hub

configuration.

Note 3-3

Downstream

Port 1 Type-C

CC1

DP1_CC1

I/O12

Used for Type-C attach and orientation

detection on Port 1. Includes configurable

Rp/Ra selection. Connect this pin directly to

the CC1 pin of the respective Type-C con-

nector.

Note 3-4

If unused: Weak pull-down

to GND. This pin may only

be left unused if Port 1 is

disabled or reconfigured to

operate in legacy Type-A

mode

t hrough

hub

configuration.

Note 3-4

TABLE 3-1:

PIN DESCRIPTIONS (CONTINUED)

Name

Symbol

Buffer

Type

Description

If Unused

VBUS_P1

43K

DP1_VBUS_MON

USB7016T/KDX Datenblatt(PDF) 13 Page - Microchip Technology

USB7016T/KDX Datenblatt(HTML) 13 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datenblatt Download

Link URL