TC ANT MOBILE...

106760_en_04

PHOENIX CONTACT

7 / 12

TC ANT MOBILE WALL 0,5M, wall mounting

•

Mount the mounting bracket. Use M5 machine screws

or self-tapping screws. You can use the bracket as a

drilling template.

•

If you wish to mount the antenna permanently, you can

also use the adhesive surface on the bottom side of the

antenna. In this case, make sure that the surface of the

bracket is clean and dry. Pull the foil off the adhesive

surface. Press the antenna firmly onto the bracket.

•

Fix the antenna firmly to the mounting bracket using the

nut and washer supplied.

Figure 7

TC ANT MOBILE WALL 0,5M, wall mounting

5.3

Mounting on a surface

Selecting the mounting location

For optimum performance, mount the antenna on a suffi-

ciently dimensioned electrically conductive grounding plate.

Plates with a thickness of 1 mm ... 13 mm and a diameter of

at least 200 mm are suitable. Note that there must be a gap

of at least 30 centimeters between the antenna and other

metallic parts.

Make sure that there is sufficient space underneath the

mounting surface.

If you use two antennas on a 4G mobile communications

device (MIMO), allow at least 20 centimeters distance

between the antennas. This way, you will achieve optimum

reception.

Mounting

•

Cover the plate around the hole to be drilled in order to

protect the surface.

•

Drill a small hole and enlarge it to a diameter of 14 mm.

Make sure that you do not damage any parts under-

neath the drill hole with the drill.

•

Clean the surface surrounding the drill hole and remove

any chipping. Remove paint and primer on the bottom

side of the plate. Sufficient electrical contact must be

ensured via the washer and the nut.

•

Remove the washer and the nut from the antenna. Pull

the foil off the adhesive surface.

•

Feed the antenna cable through the drill hole.

•

Press the antenna firmly onto the plate.

•

Secure the antenna underneath the plate using the

washer and nut. Tighten the nut.

5.4

Laying the antenna cable

•

Route the antenna cable to the device.

•

Do not route the cable in the immediate vicinity of other

cables.

•

Make sure that moving parts do not knock against the

antenna cable.

34,5

48

60

Ø

48