| Datenblatt-Suchmaschine für elektronische Bauteile |
|
400EAEBA0 Datenblatt(PDF) 34 Page - ON Semiconductor |
|
|
|||||||||||||||||||||||||||||
400EAEBA0 Datenblatt(HTML) 34 Page - ON Semiconductor |
|
34 / 47 page ![]() NCP12400 www.onsemi.com 34 Clamped Driver The supply voltage for the NCP12400 can be as high as 36 V, but most of the MOSFETs that will be connected to the DRV pin cannot accept more than 20 V on their gate. The driver pin is therefore safely clamped below 16 V. This driver has a typical capability of 500 mA for source current and 800 mA for sink current. Current−Mode Control With Slope Compensation and Soft−Start NCP12400 is a current−mode controller, which means that the FB voltage sets the peak current flowing in the transformer primary inductance and the MOSFET. This is done through a PWM comparator: the current is sensed across a resistor and the resulting voltage is applied to the CS pin. It is applied to one input of the PWM comparator through a 250 ns LEB block. On the other input the FB voltage subducted by offset typically 0.8 V and divided by 4 sets the threshold: when the voltage ramp reaches this threshold, the output driver is turned off. The maximum value for the current sense is 0.7 V, and it is set by a dedicated comparator. Each time the controller is starting, i.e. the controller was off and starts – or restarts – when VCC reaches VCC(on), a soft−start is applied: the current sense set−point is increased by 32 discrete steps from 0 (the minimum level can be higher than 0 because of the LEB and propagation delay) until it reaches VILIM (after a duration of tSSTART), or until the FB loop imposes a setpoint lower than the one imposed by the soft−start (the 2 comparators outputs are OR’ed). During the soft−start the oscillator frequency increase from the minimum switching frequency to the maximum switching frequency following the ramp applied to current sense set−point. Figure 64. Soft−Start Feature Time CS Setpoint Soft−start ramp VFB takes over soft −start tSSTART Time VFB VILIM VILIM KFB x VILIM Time OSC frequency Soft−start ramp tSSTART VILIM fSW tSSTART fSW,min Time Time |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |