BT816Q-R datasheet(27/64 Pages) BRIDGETEK

27 / 64 page

BT81X (815/6) Advanced Embedded Video Engine Datasheet

Version 1.0

Document No.: BRT_000220 Clearance No.: BRT#126

REG_PCLK is the PCLK divisor. The default value is 0, which means the PCLK output is disabled. When

REG_PCLK is none 0 (1-1023), the PCLK frequency can be calculated as:

PCLK frequency = System Clock frequency / REG_PCLK

The BT815/6 system clock frequency is programmable. Some of the possible PCLK frequencies that

BT815/6 supports are listed in Table 4-11.

REG_PCLK

System Clock Frequency (MHz)

60(default)

8.0

9.0

6.0

14.5

9.6

7.2

4.8

8.0

6.0

4.0

10.3

8.6

6.9

5.1

3.4

7.5

6.0

4.5

3.0

6.7

5.3

4.0

2.7

7.2

6.0

4.8

3.6

2.4

Table 4-11 RGB PCLK Frequency

REG_PCLK_POL defines the clock polarity, with 0 for positive active clock edge, and 1 for negative clock

edge.

REG_CSPREAD controls the transition of RGB signals with respect to the PCLK active clock edge. When

REG_CSPREAD=0, R[7:0], G[7:0] and B[7:0] signals change following the active edge of PCLK. When

REG_CSPREAD=1, R[7:0] changes a PCLK clock early and B[7:0] a PCLK clock later, which helps reduce

the switching noise.

REG_DITHER enables colour dither. This option improves the half-tone appearance on displays.

Internally, the graphics engine computes the colour values at an 8 bit precision; however, the LCD colour

at a lower precision is sufficient.

REG_OUTBITS gives the bit width of each colour channel; the default is 8/8/8 bits for each R/G/B colour.

A lower value means fewer bits are output for each channel allowing dithering on lower precision LCD

displays.

REG_SWIZZLE controls the arrangement of the output colour pins, to help the PCB route different LCD

panel arrangements. Bit 0 of the register causes the order of bits in each colour channel to be reversed.

Bits 1-3 control the RGB order. Setting Bit 1 causes R and B channels to be swapped. Setting Bit 3 allows

rotation to be enabled. If Bit 3 is set, then (R, G, B) is rotated right if bit 2 is one, or left if bit 2 is zero.

REG_SWIZZLE

RGB PINS

b3 b2 b1 b0 R7, R6,

R5, R4,

R3, R2,

R1, R0

G7, G6,

G5, G4,

G3, G2,

G1, G0

B7, B6,

B5, B4,

B3, B2,

B1, B0

R[7:0]

G[7:0]

B[7:0]

R[0:7]

G[0:7]

B[0:7]

B[7:0]

G[7:0]

R[7:0]

B[0:7]

G[0:7]

R[0:7]

B[7:0]

R[7:0]

G[7:0]

BT816Q-R Datenblatt(PDF) 27 Page - Bridgetek Pte Ltd.

BT816Q-R Datenblatt(HTML) 27 Page - Bridgetek Pte Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datenblatt Download

Link URL