AD7367

Preliminary Technical Data

Rev. PrD | Page 13 of 16

MODES OF OPERATION

The mode of operation of the AD7367 is selected by the (logic) state of the CONVST signal at the end of a conversion. There are two

possible modes of operation: normal mode and shut-down mode. These modes of operation are designed to provide flexible power

management options. These options can be chosen to optimize the power dissipation/throughput rate ratio for differing application

requirements.

NORMAL MODE

This mode is intended for applications needing fast throughput

rates since the user does not have to worry about any power-up

times with the AD7367 remaining fully powered at all times.

Figure 7 shows the general mode of operation of the AD7367 in

this mode.

The conversion is initiated on the falling edge of CONVST as

described in the Circuit Information section. To ensure that the

part remains fully powered up at all times, CONVST must be at

logic state high prior to the BUSY signal going low. If CONVST

is at logic state low when the BUSY signal goes low, the

analogue circuitry will power down and the part will cease

converting. The BUSY signal remain high for the duration of

the conversion subsequently fourteen serial clock cycles are

three-state when CS is brought high and not after 14 SCLK

cycles has elapsed. If CS is left low for a further 14 SCLK cycles,

the result from the other on chip ADC is also accessed on the

section)

returns to three-state at that point. Thus, CS must be brought

high once the read is completed, as the bus does not

automatically return to three-state upon completion of the dual

result read.

returned to three-state, another conversion can be initiated after

again.

BUSY

CONVST

SCLK

tconvert

t1

t2

SERIAL READ OPERATION

CS

1

14

tquiet

Figure 7. Normal Mode Operation

SHUT-DOWN MODE

This mode is intended for use in applications where slow

throughput rates are required. This mode is suited to

applications where a series of conversions performed at a

relatively high throughput rate are followed by a long period of

inactivity and thus, shut-down. When the AD7367 is in full

power-down, all analog circuitry is powered down. As already

stated, the falling edge of CONVST initiates the conversion.

The BUSY output subsequently goes high to indicate that the

conversion is in progress. Once the conversion is completed, the

BUSY output returns low. If the CONVST signal is at logic low

when BUSY goes low then the part will enter shut-down at the

end of the conversion phase. While the part is in shut-down

mode the digital output code from the last conversion on each

back to logic high.

To exit full power-down and power up the AD7367, A rising

edge of CONVST is required. After the required power up time

has elapsed, CONVST may be brought low again to initiate