AD9514SLASHPCB datasheet(23/28 Pages) AD

23 / 28 page

AD9514

Rev. 0 | Page 23 of 28

When the delay block is OFF (bypassed), it is also powered

down.

OUTPUTS

The AD9514 offers three different output level choices:

LVPECL, LVDS, and CMOS. OUT0/OUT0B and OUT1/

OUT1B are LVPECL differential outputs. There are three

amounts of LVPECL differential voltage swing (VOD) that can be

selected (410 mV, 790 mV, and 960 mV) within the choices

available in Table 11.

OUT2/OUT2B can be selected as either an LVDS differential

output or a pair of CMOS single-ended outputs. If selected as

CMOS, OUT2 is a noninverted, single-ended output, and

OUT2B is an inverted, single-ended output.

GND

3.3V

OUTB

OUT

Figure 31. LVPECL Output Simplified Equivalent Circuit

OUTB

OUT

3.5mA

Figure 32. LVDS Output Simplified Equivalent Circuit

OUT2/

OUT2B

Figure 33. CMOS Equivalent Output Circuit

POWER SUPPLY

The AD9514 requires a 3.3 V ± 5% power supply for VS. The

tables in the Specifications section give the performance

expected from the AD9514 with the power supply voltage

within this range. In no case should the absolute maximum

range of −0.3 V to +3.6 V, with respect to GND, be exceeded

on Pin VS.

Good engineering practice should be followed in the layout of

power supply traces and the ground plane of the PCB. The

power supply should be bypassed on the PCB with adequate

capacitance (>10 μF). The AD9514 should be bypassed with

adequate capacitors (0.1 μF) at all power pins as close as

possible to the part. The layout of the AD9514 evaluation board

(AD9514/PCB) is a good example.

AD9514/PCB Datenblatt(PDF) 23 Page - Analog Devices