USB2502 datasheet(25/44 Pages) SMSC

25 / 44 page

2-Port USB 2.0 Hub Controller

Datasheet

SMSC USB2502

Revision 2.1 (12-06-06)

DATASHEET

5.3.1.1

Byte Protocols

When using the Hub SMBus Interface for byte transfers, a write will always consist of the SMBus

Interface Slave Address byte, followed by the Internal Address Register byte, then the data byte.

The normal read protocol consists of a write to the HUB with the SMBus Interface Address byte,

followed by the Internal Address Register byte. Then restart the Serial Communication with a Read

consisting of the SMBus Interface Address byte, followed by the data byte read from the Hub. This

can be accomplished by using the Read Byte protocol.

Note:

For the following SMBus tables:

Write Byte

The Write Byte protocol is used to write data to the registers. The data will only be written if the protocol

shown in Table 5.2 is performed correctly. Only one byte is transferred at a time for a Write Byte

protocol.

Read Byte

The Read Byte protocol is used to read data from the registers. The data will only be read if the

protocol shown in Table 5.3 is performed correctly. Only one byte is transferred at a time for a Read

Byte protocol.

5.3.2

Invalid Protocol Response Behavior

Registers that are accessed with an invalid protocol are not updated. A register is only updated

following a valid protocol. The only valid protocols are Write Byte and Read Byte, which are described

above.

The Hub only responds to the hardware selected Slave Address.

Attempting to communicate with the Hub over SMBus with an invalid slave address or invalid protocol

results in no response, and the SMBus Slave Interface returns to the idle state.

The only valid registers that are accessible by the SMBus slave address are the registers defined in

the Registers Section. See Section 5.3.3 for the response to undefined registers.

5.3.3

General Call Address Response

The Hub does not respond to a general call address of 0000_000b.

Table 5.2 SMBus Write Byte Protocol

Field:

Start

Slave Addr

Ack

Reg. Addr

Ack

Reg. Data

Ack

Stop

Bits:

Table 5.3 SMBus Read Byte Protocol

Field:

Start

Slave

Addr

Ack

Reg.

Addr

Ack

Start

Slave

Addr

Ack

Reg.

Data

Nack

Stop

Bits:

Denotes Master-to-Slave

Denotes Slave-to-Master

USB2502 Datenblatt(PDF) 25 Page - SMSC Corporation

USB2502 Datenblatt(HTML) 25 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Datenblatt Download

Link URL