SNC12030

One Channel Speech Controller

5.3 RAM

SNC12030 contains 64 nibble RAM (64 x 4-bits). The 64 nibble RAM is divided into

four pages (page 0 to page 3, 16 nibble RAM on each page). In our programming

structure, users can use the instructions, PAGE n (n=0 to 3) to switch and indicate the

RAM page. Besides, users can use direct mode, M0 ~ M15 in the data transfer type

instructions, to access all 16 nibbles of each page

5.4 Power Down Mode

“End” instruction makes the IC entering into Stop Mode will stop the system clock for

power savings (<3uA @VDD=3V and <6uA @VDD=4.5V.) Any valid data transition

(L H or H L) occurring on any IO pin can be used to start the system clock and

return to normal operating mode.

5.5 Sampling Rate Counter

The unique sampling rate counter is designed in voice channel to be able to play

diverse voices at different sample playing rates. The playing rate can be adaptively set

up among from the wide ranges of 2.5KHz to 20KHz. This architecture yields a

high-quality voice synthesis that sounds very close to its original source when played

through the same amplifier and speaker circuitry.

5.6 I/O Ports

There are three 4-bit I/O ports P1, P2, and P3. Any I/O can be individually

programmed as either input pull low or output. Any valid data transition (H

L or

L H) of P1, P2 and P3 can reactivate the chip when it is in power-down stage.

Port Data

Port Status

To Internal Data Bus

Read Control

PAD

Weak

I/O Port Configuration

Note:

(1) Weak N-MOS can serve as pull-low resistor.

(2) The driving/sink current of P3.3 & P3.2 is up to 8mA/16mA

Ver: 1.4

March 17, 2005

5