AT45DB011 datasheet(2/20 Pages) ATMEL

2 / 20 page

AT45DB011

uses a serial interface to sequentially access its data. The

simple seria l interfa ce facilitates ha rdware layo ut,

increases system reliability, minimizes switching noise, and

reduces package size and active pin count. The device is

optimized for use in many commercial and industrial appli-

cations where high density, low pin count, low voltage, and

low power are essential. Typical applications for the

DataFlash are digital voice storage, image storage, and

data storage. The device operates at clock frequencies up

to 13 MHz with a typical active read current consumption of

4mA.

To allow for simple in-system reprogrammability, the

AT45DB011 does not require high input voltages for pro-

gramming. The device operates from a single power

supply, 2.7V to 3.6V, for both the program and read opera-

tions. The AT45DB011 is enabled through the chip select

pin (CS) and accessed via a three-wire interface consisting

of the Serial Input (SI), Serial Output (SO), and the Serial

Clock (SCK).

All programming cycles are self-timed, and no separate

erase cycle is required before programming.

Block Diagram

Memory Array

To provide optimal flexibility, the memory array of the

AT45DB011 is divided into three levels of granularity com-

prising of sectors, blocks, and pages. The Memory

Architecture Diagram illustrates the breakdown of each

level and details the number of pages per sector and block.

All program operations to the DataFlash occur on a page

by page basis; however, the optional erase operations can

be performed at the block or page level.

FLASH MEMORY ARRAY

PAGE (264 BYTES)

BUFFER (264 BYTES)

I/O INTERFACE

SCK

RESET

VCC

GND

RDY/BUSY

AT45DB011 Datenblatt(PDF) 2 Page - ATMEL Corporation