LMC660AI datasheet(11/14 Pages) NSC

11 / 14 page

Typical Single-Supply Applications

+ = 5.0 VDC)

Additional single-supply applications ideas can be found in

the LM324 datasheet. The LMC660 is pin-for-pin compatible

with the LM324 and offers greater bandwidth and input

resistance over the LM324. These features will improve the

performance of many existing single-supply applications.

Note, however, that the supply voltage range of the LMC660

is smaller than that of the LM324.

Low-Leakage Sample-and-Hold

00876707

Instrumentation Amplifier

00876708

If R1 = R5, R3 = R6, and R4 = R7; then

∴ A

≈100 for circuit shown.

For good CMRR over temperature, low drift resistors should

be used. Matching of R3 to R6 and R4 to R7 affect CMRR.

Gain may be adjusted through R2. CMRR may be adjusted

through R7.

Sine-Wave Oscillator

00876709

Oscillator frequency is determined by R1, R2, C1, and C2:

fosc = 1/2

πRC, where R = R1 = R2 and

C=C1=C2.

This circuit, as shown, oscillates at 2.0 kHz with a peak-to-

peak output swing of 4.5V.

1 Hz Square-Wave Oscillator

00876710

Power Amplifier

00876711

LMC660AI Datenblatt(PDF) 11 Page - National Semiconductor (TI)