Ceraliquid CPS41D and CPS41

Endress+Hauser

5

Installation

Installation instructions

Do not install the electrodes upside down. The angle of inclination must be at least 15° from the

horizontal. A smaller inclination angle is not permitted as it could cause an air bubble to form in the

glass sphere and prevent the inner electrolyte from completely wetting the pH diaphragm.

NOTICE

Before screwing in the electrode, make sure the threaded connection of the assembly is clean

and runs smoothly.

‣ Screw in the electrode finger-tight (3 Nm)! (Data apply only if installing with Endress+Hauser

assemblies.)

‣ Make sure to follow the installation instructions in the Operating Instructions of the used

assembly.

15°

15°

A

B

A0024316

 2

Electrode installation; installation angle at least 15° from the horizontal

A

Permitted orientation

B

Forbidden orientation