5.7 Timing Requirements

MIN

NOM

MAX

UNIT

POWER UP TIMING

TRSTN_PW

Minimum width to detect a valid RSTN signal assert when the pin is actively

driven low

100

µs

TSTABLE

VCC must be stable before RSTN de-assertion

300

µs

TREADY

Maximum time needed for the device to be ready after RSTN is de-

asserted.

500

µs

TRAMP

VCC ramp time

100

ms

TRAMP

VCC ramp time

0.2

ms

5.8 Typical Characteristics

The typical characteristics shown in this section apply to near-end eye measurements taken at nominal conditions. The eyes

are measured with various pre-channel cable lengths applied at the input or post-channel cable lengths applied at the output

of the TUSB211A-Q1 as indicated.

Figure 5-1. 2 Meter Pre-Channel With TUSB211A-Q1 EQ=1

Figure 5-2. 5 Meter Pre-Channel With TUSB211A-Q1 EQ=2

Figure 5-3. 2 Meter Post-Channel With TUSB211A-Q1 EQ=1

Figure 5-4. 4 Meter Post-Channel With TUSB211A-Q1 EQ=2

TUSB211A-Q1

SLLSFX8 – FEBRUARY 2024

www.ti.com

6

Submit Document Feedback

Copyright © 2024 Texas Instruments Incorporated

Product Folder Links: TUSB211A-Q1