EV1541DJ-TFT-00A – MP1541 TFT APPLICATIONS EVALUATION BOARD

EVALUATION BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV1541DJ-TFT-00A Rev. 1.0

www.MonolithicPower.com

5

6/8/2005

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2005 MPS. All Rights Reserved.

TM

QUICK START GUIDE

The output voltage of this board is set to 5V, –10V and 15V on VOUT, VN and VP, respectively. The

board layout accommodates most commonly used inductors and output capacitors.

1. Preset the power supply to 3V

2. Turn off the power supply.

3. Connect the power supply terminals to:

a. Positive (+): VIN, EN

b. Negative (–): GND

4. Connect the load to:

a. Positive (+): VOUT, VP, GND (for the negative output)

b. Negative (–): GND, VN (for the negative output)

5. Turn on the power supply after making the connections.

6. The MP1541 is disabled on the evaluation board if only VIN is applied. To enable the MP1541,

EN needs to be pulled HIGH.

formula:

2

R

1

V

V

1

R

FB

OUT

⎟⎟

⎠

⎞

⎜⎜

⎝

⎛

−

=

Ω

=

Ω

×

⎟

⎠

⎞

⎜

⎝

⎛

−

=

k

50

k

10

1

V

25

.

1

V

5

.

7

1

R

Therefore use a 49.9kΩ standard 1% value resistor.