SN74LVTH574DBLE datasheet(3/23 Pages) TI

3 / 23 page

SN54LVTH574, SN74LVTH574

3.3V ABT OCTAL EDGETRIGGERED DTYPE FLIPFLOPS

WITH 3STATE OUTPUTS

SCBS688G − MAY 1997 − REVISED SEPTEMBER 2003

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

logic diagram (positive logic)

CLK

To Seven Other Channels

Pin numbers shown are for the DB, DW, FK, J, NS, PW, RGY, and W packages.

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

−0.5 V to 4.6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

−0.5 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Voltage range applied to any output in the high-impedance

or power-off state, VO (see Note 1)

−0.5 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Voltage range applied to any output in the high state, VO (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . .

Current into any output in the low state, IO: SN54LVTH574

96 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

SN74LVTH574

128 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Current into any output in the high state, IO (see Note 2): SN54LVTH574

48 mA

. . . . . . . . . . . . . . . . . . . . . . .

SN74LVTH574

64 mA

. . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0)

−50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0)

−50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance,

θJA (see Note 3): DB package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(see Note 3): DW package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(see Note 3): GQN/ZQN package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . .

(see Note 3): NS package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(see Note 3): PW package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(see Note 4): RGY package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range, Tstg

−65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.

2. This current flows only when the output is in the high state and VO > VCC.

3. The package thermal impedance is calculated in accordance with JESD 51-7.

4. The package thermal impedance is calculated in accordance with JESD 51-5.

SN74LVTH574DBLE Datenblatt(PDF) 3 Page - Texas Instruments

SN74LVTH574DBLE Datenblatt(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Datenblatt Download

Link URL