VL53L4ED datasheet(28/39 Pages) STMICROELECTRONICS

28 / 39 page

Field of view and field of illumination

The Rx (or collector) exclusion zone includes all module assembly tolerances and is used to define the cover

glass dimensions. The cover glass opening must be equal to or wider than the exclusion zone.

The detection volume represents the applicative or system FoV in which a target is detected, and a distance

measured. It is determined by the Rx lens or the Rx aperture, and is narrower than the exclusion zone.

Figure 27. System FoV and exclusion zone description (not to scale)

Table 18. FoV angles

Setting

Target at 100 mm (white 88%)

Target at 1000 mm (white 88%)

Detection volume (°)

22°

18°

Collector exclusion cone (°)

25°

Note:

Detection volume depends on the environment and sensor configuration as well as target distance, reflectance,

ambient light level, sensor timing budget, distance mode, and tuning parameters.

Note:

The detection volume of Table 18. FoV angles has been measured with a white 88% reflectance perpendicular

target in full FoV, located at 100 mm and 1000 mm from the sensor, without ambient light (dark conditions),

using the default driver configuration.

The VCSEL FoI is shown in the figure below. The X-axis is 16° and the Y-axis is 16° (1/e²).

Figure 28. VL53L4ED FoI

VL53L4ED

Field of view and field of illumination

DS14256 - Rev 3

page 28/39

VL53L4ED Datenblatt(PDF) 28 Page - STMicroelectronics