SC1185ACSW.TR datasheet(8/14 Pages) SEMTECH

8 / 14 page

 2005 Semtech Corp.

www.semtech.com

POWER MANAGEMENT

SC1185 & SC1185A

Layout Guidelines

4) The Output Capacitor(s) (Cout) should be located as

close to the load as possible, fast transient load cur-

rents are supplied by Cout only, and connections between

Cout and the load must be short, wide copper areas to

minimize inductance and resistance.

5) The SC1185 is best placed over a quiet ground plane

area, avoid pulse currents in the Cin, Q1, Q2 loop flowing

in this area. PGNDH and PGNDL should be returned to

the ground plane close to the package. The AGND pin

should be connected to the ground side of (one of) the

output capacitor(s). If this is not possible, the AGND pin

may be connected to the ground path between the Output

Capacitor(s) and the Cin, Q1, Q2 loop. Under no circum-

stances should AGND be returned to a ground inside the

Cin, Q1, Q2 loop.

6) Vcc for the SC1185 should be supplied from the 5V

Currents in various parts of the power section

supply through a 10

Ω resistor, the Vcc pin should be

decoupled directly to AGND by a 0.1

µF ceramic capacitor,

trace lengths should be as short as possible.

7) The Current Sense resistor and the divider across it

should form as small a loop as possible, the traces run-

ning back to CS+ and CS- on the SC1185 should run

parallel and close to each other. The 0.1

µF capacitor should

be mounted as close to the CS+ and CS- pins as possible.

8) Ideally, the grounds for the two LDO sections should be

returned to the ground side of (one of) the output

capacitor(s).

Vout

SC1185ACSW.TR Datenblatt(PDF) 8 Page - Semtech Corporation