TMP86FS28DFG datasheet(14/272 Pages) TOSHIBA

14 / 272 page

Page 2

1.1 Features

TMP86FS28DFG

Programmable pulse generation (PPG) modes

8. 8-bit UART/SIO: 1 ch

9. 8-bit UART : 1 ch

10. 10-bit successive approximation type AD converter

- Analog input: 8 ch

11. Key-on wakeup : 4 ch

12. LCD driver/controller

Built-in voltage booster for LCD driver With display memory

LCD direct drive capability (MAX 40 seg

× 4 com)

1/4,1/3,1/2duties or static drive are programmably selectable

13. Clock operation

Single clock mode

Dual clock mode

14. Low power consumption operation

STOP mode: Oscillation stops. (Battery/Capacitor back-up.)

SLOW1 mode: Low power consumption operation using low-frequency clock.(High-frequency clock

stop.)

SLOW2 mode: Low power consumption operation using low-frequency clock.(High-frequency clock

oscillate.)

IDLE0 mode: CPU stops, and only the Time-Based-Timer(TBT) on peripherals operate using high fre-

quency clock. Release by falling edge of the source clock which is set by TBTCR<TBTCK>.

IDLE1 mode: CPU stops and peripherals operate using high frequency clock. Release by interru-

puts(CPU restarts).

IDLE2 mode: CPU stops and peripherals operate using high and low frequency clock. Release by inter-

ruputs. (CPU restarts).

SLEEP0 mode: CPU stops, and only the Time-Based-Timer(TBT) on peripherals operate using low fre-

quency clock.Release by falling edge of the source clock which is set by TBTCR<TBTCK>.

SLEEP1 mode: CPU stops, and peripherals operate using low frequency clock. Release by interru-

put.(CPU restarts).

SLEEP2 mode: CPU stops and peripherals operate using high and low frequency clock.

Release by

interruput.

15. Wide operation voltage:

2.7 V to 5.5 V at 8MHz /32.768 kHz

4.0 V to 5.5 V at 16 MHz /32.768 kHz

TMP86FS28DFG Datenblatt(PDF) 14 Page - Toshiba Semiconductor