ST10F272E datasheet(83/181 Pages) STMICROELECTRONICS

Teilenummer	ST10F272E

Bauteilbeschribung	16-bit MCU with 256 Kbyte Flash memory and 12/20 Kbyte RAM

PDF	181 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

83 / 181 page

ST10F272B/ST10F272E

System reset

83/181

sufficient: anyway, a maximum of 100nF on V18 pin should

not generate problems of over-current (higher value is

allowed if current is limited by the external hardware).

External current limitation is anyway recommended also to

avoid risks of damage in case of temporary short between

V18 and ground: the internal 1.8V drivers are sized to drive

currents of several tens of Ampere, so the current shall be

limited by the external hardware. The limit of current is

imposed by power dissipation considerations (Refer to

Electrical Characteristics Section).

In next Figures

17 and 18 Asynchronous Power-on timing diagrams are reported,

respectively with boot from internal or external memory, highlighting the reset phase

extension introduced by the embedded FLASH module when selected.

Note:

Never power the device without keeping RSTIN pin grounded: the device could enter in

unpredictable states, risking also permanent damages.

ST10F272E Datenblatt(PDF) 83 Page - STMicroelectronics