PCM5100, PCM5101, PCM5102

www.ti.com

SLAS764B – MAY 2011 – REVISED SEPTEMBER 2012

ELECTRICAL CHARACTERISTICS (continued)

All specifications at TA = 25°C, AVDD = CPVDD = DVDD = 3.3V, fS = 48kHz, system clock = 512 fS and 24-bit data unless

otherwise noted.

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

Dynamic Performance (PCM Mode)(2)(3) (Values shown for three devices PCM5102/PCM5101/PCM5100)

fS = 48kHz

–93/–92/–90

-83/ -82/ -80

THD+N at –1 dBFS(3)

fS = 96kHz

–93/–92/–90

fS = 192kHz

–93/–92/–90

Dynamic range(3)

EIAJ, A-weighted, fS = 48kHz

106/ 100/ 95

112/106/100

EIAJ, A-weighted, fS = 96kHz

112/106/100

EIAJ, A-weighted, fS = 192kHz

112/106/100

Signal-to-noise ratio(3)

EIAJ, A-weighted, fS = 48kHz

112/106/100

dB

EIAJ, A-weighted, fS = 96kHz

112/106/100

EIAJ, A-weighted, fS = 192kHz

112/106/100

Signal to noise ratio with

EIAJ, A-weighted, fS = 48kHz

113

123

analog mute(3)(4)

EIAJ, A-weighted, fS = 96kHz

123

EIAJ, A-weighted, fS = 192kHz

123

Channel Separation

fS = 48 kHz

100/ 95/ 90

109/103/97

fS = 96kHz

109/103/97

fS = 192kHz

109/103/97

Analog Output

Output voltage

2.1

VRMS

Gain error

–6

±2.0

6

% of FSR

Gain mismatch, channel-to-

–6

±2.0

6

% of FSR

channel

Bipolar zero error

At bipolar zero

–5

±1.0

5

mV

Load impedance

1

k

Ω

Filter Characteristics–1: Normal

Pass band

0.45fS

Stop band

0.55fS

Stop band attenuation

–60

dB

Pass-band ripple

±0.02

Delay time

20/fS

s

Filter Characteristics–2: Low Latency

Pass band

0.47fS

Stop band

0.55fS

Stop band attenuation

–52

dB

Pass-band ripple

±0.0001

Delay time

3.5/fS

s

(2)

Filter condition: THD+N: 20Hz HPF, 20kHz AES17 LPF Dynamic range: 20Hz HPF, 20kHz AES17 LPF, A-weighted Signal-to-noise

ratio: 20Hz HPF, 20kHz AES17 LPF, A-weighted Channel separation: 20Hz HPF, 20kHz AES17 LPF Analog performance specifications

are measured using the System Two Cascade™ audio measurement system by Audio Precision™ in the RMS mode.

(3)

Output load is 10k

Ω, with 470Ω output resistor and a 2.2nF shunt capacitor (see recommended output filter).

(4)

Assert XSMT or both L-ch and R-ch PCM data are BPZ

Copyright © 2011–2012, Texas Instruments Incorporated

Submit Documentation Feedback

5

Product Folder Links: PCM5100 PCM5101 PCM5102