SCALE™-2 2SC0635T2A1-45

Preliminary Data Sheet

www.power.com/igbt-driver

Page 6

15)

Partial discharge measurement is performed in accordance with IEC 60270 and isolation coordination

specified in IEC 60664-1. The partial discharge extinction voltage between primary and either

secondary side is coordinated for basic isolation to IEC 60664-1.

16)

Jitter measurements are performed with input signals INx switching between 0V and 15V referred to

GND, with a corresponding rise time and fall time of 6ns.

17)

The minimum operating temperature is limited to -40°C for the first series. This will be extended

to -55°C upon completion of the ongoing qualification program.

18)

The VCE–monitoring threshold value can be reduced with an external resistor. Refer to “2SC0635T

Description & Application Manual”.

19)

The turn-off event of the IGBT after a secondary-side fault (IGBT short circuit or undervoltage

monitoring) can be additionally delayed with an external capacitor. Refer to “2SC0635T Description &

Application Manual”.

RoHS Statement

On the basis of Annexes II and III of European Directive 2011/65/EC of 08 June 2011 on the restriction of the

use of certain hazardous substances in electrical and electronic equipment (RoHS), we hereby state that the

products described in this datasheet do not contain lead (Pb), mercury (Hg), hexavalent chromium (Cr VI),

cadmium (Cd), polibrometo of biphenyl (PBB) or polibrometo diphenyl ether (PBDE) in concentrations

exceeding the restrictions set forth in Annex II of 2011/65/EC with due consideration of the applicable

exemptions as listed in Annex III of 2011/65/EC.

Legal Disclaimer

The statements, technical information and recommendations contained herein are believed to be accurate as

of the date hereof. All parameters, numbers, values and other technical data included in the technical

information were calculated and determined to our best knowledge in accordance with the relevant technical

norms (if any). They may base on assumptions or operational conditions that do not necessarily apply in

general. We exclude any representation or warranty, express or implied, in relation to the accuracy or

completeness of the statements, technical information and recommendations contained herein. No

responsibility is accepted for the accuracy or sufficiency of any of the statements, technical information,

recommendations or opinions communicated and any liability for any direct, indirect or consequential loss or

damage suffered by any person arising therefrom is expressly disclaimed.