Board Information

4

11/2/2022

Copyright © Infineon Technologies AG 2022. All rights reserved.

MAKE SURE THAT NO VOLTAGE

APPLIED TO ANY OF THE PINS

EXCEEDS THE ABSOLUTE

MAXIMUM RATING OF 4 V

XMC2Go

DPS310/368

Breakble

Head

I²C/SPI Switch

Connect the Micro-USB to your PC to power up the Kit2Go. PWR LED

turns green indicating proper power supply

Micro-USB delivers 5 V to power-up the Kit2Go. When breaking the board

apply no more than 3.3 V to the DPS

Pin out on the bottom (HEAD) is directly connected to the pins of the

DPS310/368

If the head is broken off:

− Two capacitors are connected to the DPS310/368

− MCU and Debugger can still be used

To use the I²C mode, place a pull-up resistors on the lines between

VDDIO-SDI and VDDIO-SCK (max. 10k

Ω each)

− Debugger can also be accessed via SV1

Software compatible with Arduino and library fully integrated into the

Arduino IDE with help of

Infineon’s GitHub page.

Standard delivery of the board (in terms of interface mode) is I²C with

Address 0x77 when the 0 Ohm resistors are soldered as shown on the

right picture

Sales Name: KIT_DPS310_2GO and KIT_DPS368_2GO